Filter
Top Products
5: Commands and Levels
response type text
Uses text type responses.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current
CLI session.
show status
Displays tunnel modem status.
verbose response disable
Does not send Modem Response Codes.
verbose response enable
Sends Modem Response Codes out on the Serial Line.
write
Stores the current configuration in permanent memory.
packing (tunnel-packing:1) level commands
clrscrn
Clears the screen.
default packing mode
Sets to default packing mode, which is "Disable"
default send character
Removes the send character for packing mode.
default threshold
Restores the default threshold.
default timeout
Restores the default packing mode timeout.
exit
Returns to the tunnel level.
no trailing character
Removes the trailing character for packing mode.
packing mode disable
Disables packing. Data is sent to the network when re-
ceived.
packing mode send character
Sets packing mode to accumulate data and transmit it
upon receiving the
configured send character on the line (serial port).
packing mode timeout
Sets packing mode to accumulate data and transmit it
after a specified
amount of time (timeout).
send character <control>
Sets the send character for packing mode.
The character may be input as text, control, decimal, or
hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current
CLI session.
threshold <bytes>
Sets the threshold (byte count). If the queued data reach-
es this threshold
then the data will be sent.
<bytes> = number of bytes in the threshold.
timeout <milliseconds>
Sets the timeout value for packing mode in milliseconds.
<milliseconds> = timeout value, in milliseconds.
trailing character <control>
Sets the trailing character for packing mode.
The character may be input as text, control, decimal, or
hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
write
Stores the current configuration in permanent memory.
password (tunnel-accept-password:1) level commands
clrscrn
Clears the screen.
exit
Exits to the next higher level.
no password
Removes the password so connections will be accepted
XPort® Pro Lx6 Embedded Device Server Command Reference 81