Filter
Top Products
Table 6. Security menu items (continued)
Menu item
Submenu item
Value
Comments
Intel AT Module
Activation
• Disabled
• Enabled
• Permanently
Disabled
Enable or disable the UEFI BIOS interface to
activate the Intel AT module, which is an optional
anti-theft service from Intel.
Note: If you set the Intel AT module activation
to Permanently Disabled, you will be unable to
enable this setting again.
Intel AT Suspend
• Enter
This option is displayed only when the anti-theft
function is activated.
The Intel anti-theft suspend screen will be
displayed at next boot to enter the suspend
mode.
Anti-Theft
Computrace Module
Activation
• Disabled
• Enabled
• Permanently
Disabled
Enable or disable the UEFI BIOS interface to
activate the computrace module. Computrace
is an optional monitoring service from Absolute
Software.
Note: If you set the computrace module
activation to Permanently Disabled, you will be
unable to enable this setting again.
Startup menu
To change the computer startup settings,, select Startup from the ThinkPad Setup main menu.
Attention:
• After you change your startup sequence, you must be extremely careful not to specify a wrong device
during a copy, a save, or a format operation. If you specify a wrong device, your data and programs
might be erased or overwritten.
• If you are using the BitLocker drive encryption, you should not change the startup sequence. BitLocker
drive encryption detects the change of startup sequence and locks the computer from booting.
Changing the startup sequence
To change the startup sequence, do the following:
1. Select Boot or Network, then press Enter. The default boot list is displayed, showing the order in which
devices will be started up. Even devices that are not attached to or installed on your computer are listed.
• Use the Boot submenu to specify the startup sequence that runs when you turn on the power.
• Use the Network submenu to specify the startup sequence that runs when Wake on LAN is enabled.
Wake on LAN is commonly used by LAN administrators in corporate networks to get remote access
to your computer.
2. Set the startup sequence by using the following keys:
• Use cursor keys to select a device.
• Use F6 or the combination of Shift and + to move the device up to a higher priority.
• Use F5 or – to move the device down to a lower priority.
• Use the combination of Shift and ! to exclude or include a device.
3. Press F10 to save the changes and restart the system.
Chapter 8. Advanced conguration 119