Filter
Top Products
Enhancing photos automatically
1 Load photo paper with the glossy or printable side facing you. (If you are not sure which side is the printable side,
see the instructions that came with the paper.) For more information, see “Loading paper” on page 19.
2 Insert a memory card or flash drive. For more information, see “Inserting a memory card” on page 20 or “Inserting
a flash drive” on page 21.
3 Press or repeatedly until View and Select appears on the display.
4 Press .
5 Press to continue.
6 Press or to navigate through the photos.
7 Press to select a photo for printing.
8 Press .
The Photo Edit Mode menu appears.
9 Press or repeatedly until Auto Enhance appears on the display.
10 Press or to select On.
Note: The image on the display does not accurately reflect the image when printed.
11 Press to save your selection and go back to the photo selection screen.
An icon appears on the bottom of the display to indicate that the photo will be auto enhanced when printed.
12 Press or to select the number of copies to print.
Note: Pressing
when the number of copies is set to 1 will deselect the image. Pressing when the image is
not selected will select the image.
13 You can select more photos for printing and editing by repeating step 6 through step 12.
14 Press to go to the Print Preview screen.
15 If you want to adjust the print settings:
a Press .
b Make your selections.
c Press to save your selections, and then go back to the Print Preview screen.
16 Press to print.
Note: To prevent smudging or scratching, avoid touching the printed surface with your fingers or sharp objects.
For best results, remove each printed sheet individually from the paper exit tray, and allow the prints to dry at
least 24 hours before stacking, displaying, or storing.
Editing photos
32