Filter
Top Products
93Operations - TN3270E SETUP: NETWORK SETUP > Connect Status
Reconnecting session The Telnet session was disconnected. The SCS/TNe Emulation is
attempting to reconnect.
Session Disconnected and Halted All active Telnet sessions have been disconnected. Power the
printer Off and On or select Menus > Option Card Menu > SCS/
TNe MENU > COMMON SETUP > Reset TN Session > Reset TN
Ses. to reconnect.
Trying to connect The SCS/TNe Emulation is contacting the host or SNA Server to
establish a TCP/IP connection.
Connect Status: Last response messages Comments
Lst Rsp:No support for that device-type The Telnet server does NOT support the device type requested by
the SCS/TNe Emulation. Select another device type with the Device
Type option.
Lst Rsp:Name unknown to server The LU Name requested by the SCS/TNe Emulation is unknown to
the server or not correctly configured. Check the configuration of
the host and of the SCS/TNe Emulation.
Lst Rsp:The requested device is in use The device requested by the SCS/TNe Emulation is used by
another device. Check the configuration of the host and of the SCS/
TNe Emulation.
Lst Rsp:Terminal/Printer name mismatch The device name or resource name requested by the SCS/TNe
Emulation is incompatible with the requested device type. Change
the device name or device type on the host or check the configu-
ration of the host and of the SCS/TNe Emulation.
Connect Status: Primary status messages Comments