Filter
Top Products
27
9.2.5. Removing the SW Board
Preparation : perform the section 9.2.1. to 9.2.3.
first.
1. Peel off the tape.
2. Remove the solenoid cable.
3. Remove the 1 screw (M) and then remove the SW
board.
Screw (M) : DXHM0057ZA (N7)
Note:
Note it that the disc eject knob comes off at the same
time.
4. Remove the 3 screws (G), 2 screws (H), 2 screws
(I), 2 screws (J), 2 screws (K) and 1 screw (L) from
the top case.
Screw (G) : DXQT2+E6FNL (N13)
Screw (H) : DXQT26+D8FCL (N16)
Screw (I) : DXQT2+E6FCL (N12)
Screw (J) : DFHE5025XA (N1)
Screw (K) : DXQT2+E12FNL (N11)
Screw (L) : DXQT2+E6FNL (N13)
5. Lift up the top case, remove the pad FFC and then
remove the top case.
Screw (H)
Screw
(H)
Screw (G)
Screw (G)
Screw
(K)
Screw (K)
Screw (J)
Screw (I)
Screw (I)
Screw
(G)
Disc Cover
Screw
(S)
Screw (J)
FFC (SW)
Top Case
FFC (PAD)
Top Case
Screw (Q)
Disc Eject Knob
Switch Board
Solenoid Cable
Tape