Filter
Top Products
34
9.2.22. Removing the WWAN Antenna
Board (MAIN), (SUB)
Preparation : perform the section 9.2.1., 9.2.2.,1
9.2.4. and 9.2.13. to 9.2.18. to 9.2.20. and 9.2.22.
first.
1. Open the SIMM cover and then remove the 2
screws (a).
Screw (a) : DXHM0057ZA (N7)
2. Remove the antenna cover.
3. Peel off the LCD hold sheet.
LCD Hold Sheet : DFHR3E92ZA (K1013)
4. Peel off the 2 cable fixed sheets and cable blind
sheet.
Cable Fixed Sheet : DFHR8526ZA (K1023)
Cable Blind Sheet : DFGX0475ZA (K1016)
5. Remove the each 2 screws (b) and then remove the
antenna board (MAIN), (SUB).
Screw (b) : DFHE5025XA (N1)
9.2.21. Removing the Inverter Board
Preparation : perform the section 9.2.1., 9.2.2.,1
9.2.4. and 9.2.13. to 9.2.18. to 9.2.20. first.
1. Remove the LCD Cable from the Inverter.
2. Peel off the Tape for fixation from Inverter Case.
3. Remove the Inverter with the Inverter Case.
LCD Hook
Gasket Cloth
Inverter Box
Tape
LCD Cable
LCD High voltage
2pin Wire Rod
LCD Front Case
LCD Rear
SIMM Cover
Screw (a)
Antenna Cover
Cable Fixed Sheet
Cable Blind Sheet
LCD Rear
LCD Hold Sheet
WWAN Antenna
Board (MAIN)
WWAN Antenna
Board (SUB)
Antenna
Cable
Antenna
Cable
Screw (V)