Filter
Top Products
VLAN identifier. When GVRP group creates, each dynamic VLAN group owns its VID. Valid range is 1
~ 4094.
y Member Port:
Those are the members belonging to the same dynamic VLAN group.
y Edit Administrative Control:
When you create GVRP group, you can use Administrative Control function to change Applicant Mode
and Registrar Mode of GVRP group member.
y Refresh:
Refresh function can help you to see current GVRP group status.
3.12 STP
The Spanning Tree Protocol (STP) is a standardized method (IEEE 802.1D) for avoiding loops in switched
networks. When STP is enabled, ensure that only one path is active between any two nodes on the network at
a time. User can enable Spanning Tree Protocol on switch’s web management and then set up other
advanced items. We recommend that you enable STP on all switches to ensure a single active path on the
network.
3.12.1 Status
In the Spanning Tree Status, user can read 12 parameters to know STP current status. The 12 parameters’
description is listed in the following table.
Parameter description:
y STP State:
Show the current STP Enabled / Disabled status. Default is “Disabled”.
y Bridge ID:
Show switch’s bridge ID which stands for the MAC address of this switch.
y Bridge Priority:
Show this switch’s current bridge priority setting. Default is 32768.
y Designated Root:
Show root bridge ID of this network segment. If this switch is a root bridge, the “Designated Root” will
show this switch’s bridge ID.
y Designated Priority:
36