Filter
Top Products
Command Line Interface
4-72
4
authentication is attempted on the TACACS+ server. If the TACACS+ server
is not available, the local user name and password is checked.
Example
Related Commands
enable password - sets the password for changing command modes (4-28)
RADIUS Client
Remote Authentication Dial-in User Service (RADIUS) is a logon authentication
protocol that uses software running on a central server to control access to
RADIUS-aware devices on the network. An authentication server contains a
database of multiple user name/password pairs with associated privilege levels for
each user or group that require management access to a switch.
radius-server host
This command specifies the RADIUS server. Use the no form to restore the default.
Syntax
radius-server host host_ip_address
no radius-server host
host_ip_address - IP address of server.
Default Setting
10.1.0.1
Command Mode
Global Configuration
Example
Console(config)#authentication enable radius
Console(config)#
Table 4-28 RADIUS Client Commands
Command Function Mode Page
radius-server host Specifies the RADIUS server GC 4-72
radius-server port Sets the RADIUS server network port GC 4-73
radius-server key Sets the RADIUS encryption key GC 4-73
radius-server retransmit Sets the number of retries GC 4-74
radius-server timeout Sets the interval between sending authentication requests GC 4-74
show radius-server Shows the current RADIUS settings PE 4-74
Console(config)#radius-server host 192.168.1.25
Console(config)#