Filter
Top Products
SNMP Commands
4-113
4
SNMP Commands
Controls access to this switch from management stations using the Simple Network
Management Protocol (SNMP), as well as the error types sent to trap managers.
SNMP Version 3 also provides security features that cover message integrity,
authentication, and encryption; as well as controlling user access to specific areas of
the MIB tree. To use these commands, first configure an SNMP engine ID, specify
read and write access views for the MIB tree, configure SNMP user groups with the
required security model (i.e., SNMP v1, v2c or v3) and security level (i.e.,
authentication and privacy), and then assign SNMP users to these groups, along
with their specific authentication and privacy passwords.
snmp-server
This command enables the SNMPv3 engine and services for all management clients
(i.e., versions 1, 2c, 3). Use the no form to disable the server.
Syntax
[no] snmp-server
Default Setting
Enabled
Table 4-38 SNMP Commands
Command Function Mode Page
snmp-server Enables the SNMP agent GC 4-113
show snmp Displays the status of SNMP communications NE, PE 4-114
snmp-server community Sets up the community access string to permit access to
SNMP commands
GC 4-115
snmp-server contact Sets the system contact string GC 4-115
snmp-server location Sets the system location string GC 4-116
snmp-server host Specifies the recipient of an SNMP notification operation GC 4-117
snmp-server enable traps Enables the device to send SNMP traps (i.e., SNMP
notifications)
GC 4-118
snmp-server engine-id Sets the SNMP engine ID GC 4-119
show snmp engine-id Shows the SNMP engine ID PE 4-119
snmp-server view Adds an SNMP view GC 4-120
show snmp view Shows the SNMP views PE 4-121
snmp-server group Adds an SNMP group, mapping users to views GC 4-121
show snmp group Shows the SNMP groups PE 4-123
snmp-server user Adds a user to an SNMP group GC 4-124
show snmp user Shows the SNMP users PE 4-125
snmp ip filter Sets IP addresses of clients allowed management access to
the switch via SNMP
GC 4-121