Filter
Top Products
VLAN Commands
4-191
4
Configuring VLAN Interfaces
interface vlan
This command enters interface configuration mode for VLANs, which is used to
configure VLAN parameters for a physical interface.
Syntax
interface vlan vlan-id
vlan-id - ID of the configured VLAN. (Range: 1-4094, no leading zeroes)
Default Setting
None
Command Mode
Global Configuration
Example
The following example shows how to set the interface configuration mode to
VLAN 1, and then assign an IP address to the VLAN:
Related Commands
shutdown (4-154)
Table 4-58 Commands for Configuring VLAN Interfaces
Command Function Mode Page
interface vlan Enters interface configuration mode for a specified VLAN IC 4-191
switchport mode Configures VLAN membership mode for an interface IC 4-192
switchport
acceptable-frame-types
Configures frame types to be accepted by an interface IC 4-192
switchport ingress-filtering Enables ingress filtering on an interface IC 4-193
switchport native vlan Configures the PVID (native VLAN) of an interface IC 4-194
switchport allowed vlan Configures the VLANs associated with an interface IC 4-195
switchport gvrp Enables GVRP for an interface IC 4-204
switchport forbidden vlan Configures forbidden VLANs for an interface IC 4-196
switchport priority default Sets a port priority for incoming untagged frames IC 4-209
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#