Filter
Top Products
IP Routing Commands
4-265
4
Default Setting
1
Command Usage
• If you enter this command for a normal area, it will changed to a stub.
• If the default cost is set to “0,” the router will not advertise a default route into
the attached stub or NSSA.
Example
Related Commands
area stub (4-268)
summary-address
This command aggregates routes learned from other protocols. Use the no form to
remove a summary address.
Syntax
[no] summary-address summary-address netmask
• summary-address - Summary address covering a range of addresses.
• netmask - Network mask for the summary route.
Command Mode
Router Configuration
Default Setting
Disabled
Command Usage
• An Autonomous System Boundary Router (ASBR) can redistribute routes
learned from other protocols by advertising an aggregate route into all
attached autonomous systems.
• This router supports up 16 Type-5 summary routes.
Example
This example creates a summary address for all routes contained in 192.168.x.x.
Related Commands
area range (4-264)
Console(config-router)#area 10.3.9.0 default-cost 10
Console(config-router)#
Console(config-router)#summary-address 192.168.0.0 255.255.0.0
Console(config-router)#