Filter
Top Products
Multicast Filtering Commands
4-227
4
Default Setting
300 seconds
Command Mode
Global Configuration
Command Usage
The switch must use IGMPv2 for this command to take effect.
Example
The following shows how to configure the default timeout to 300 seconds:
Related Commands
ip igmp snooping version (4-222)
Static Multicast Routing Commands
ip igmp snooping vlan mrouter
This command statically configures a multicast router port. Use the no form to
remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
• vlan-id - VLAN ID (Range: 1-4094)
• interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-6)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Console(config)#ip igmp snooping router-port-expire-time 300
Console(config)#
Table 4-72 Static Multicast Routing Commands
Command Function Mode Page
ip igmp snooping vlan
mrouter
Adds a multicast router port GC 4-227
show ip igmp snooping
mrouter
Shows multicast router ports PE 4-228