Filter
Top Products
Command Line Interface
4-304
4
PIM-DM Multicast Routing Commands
router pim
This command enables Protocol-Independent Multicast - Dense Mode (PIM-DM)
globally for the router and to enter router configuration mode. Use the no form to
disable PIM-DM multicast routing.
Syntax
[no] router pim
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
This command enables PIM-DM globally for the router. You also need to
enable PIM-DM for each interface that will support multicast routing using the
ip pim dense-mode command (page 4-305), and make any changes
necessary to the multicast protocol parameters.
Table 4-105 PIM-DM Multicast Routing Commands
Command Function Mode Page
router pim Enables PIM globally for the router GC 4-304
ip pim dense-mode Enables PIM on the specified interface IC 4-305
ip pim hello-interval Sets the interval between sending PIM hello messages IC 4-306
ip pim hello-holdtime Sets the time to wait for hello messages from a neighboring
PIM router before declaring it dead
IC 4-306
ip pim trigger-hello-interval Sets the maximum time before sending a triggered PIM
Hello message
IC 4-307
ip pim join-prune-holdtime Configures the hold time for the prune state IC 4-307
ip pim graft-retry-interval Configures the time to wait for a Graft acknowledgement
before resending a Graft message
IC 4-308
ip pim max-graft-retries Configures the maximum number of times to resend a Graft
message if it has not been acknowledged
IC 4-309
show router pim Displays the global PIM configuration settings NE, PE 4-309
show ip pim interface Displays information about interfaces configured for PIM NE, PE 4-309
show ip pim neighbor Displays information about PIM neighbors NE, PE 4-310