Filter
Top Products
Configuring the Switch
3-16
3
Command Attributes
•VLAN – ID of the configured VLAN (1-4094, no leading zeroes). By default, all
ports on the switch are members of VLAN 1. However, the management station
can be attached to a port belonging to any VLAN, as long as that VLAN has been
assigned an IP address.
• IP Address Mode – Specifies whether IP functionality is enabled via manual
configuration (Static), Dynamic Host Configuration Protocol (DHCP), or Boot
Protocol (BOOTP). If DHCP/BOOTP is enabled, IP will not function until a reply has
been received from the server. Requests will be broadcast periodically by the
switch for an IP address. (DHCP/BOOTP values can include the IP address,
subnet mask, and default gateway.)
• IP Address – Address of the VLAN to which the management station is attached.
(Note you can manage the switch through configured IP interface.) Valid IP
addresses consist of four numbers, 0 to 255, separated by periods.
(Default: 0.0.0.0)
• Subnet Mask – This mask identifies the host address bits used for routing to
specific subnets. (Default: 255.0.0.0)
• Default Gateway – IP address of the gateway router between this device and
management stations that exist on other network segments. (Default: 0.0.0.0)
Manual Configuration
Web – Click IP, General, Routing Interface. Select the VLAN through which the
management station is attached, set the IP Address Mode to “Static,” and specify a
“Primary” interface. Enter the IP address, subnet mask and gateway, then click
Apply.
Figure 3-6 IP Interface Configuration - Manual