Mitsubishi Electronics T-60 Calculator User Manual


 
Using The T-60 With One or More DX Drives
Connecting the T-60 to the DX drive(s) is very simple when the proper cables
are used. The Figure below illustrates the required cables and what they
should be connected to. The PC’s COM1 or COM2 is connected to COM2 on
the T-60. Note that the cable used for this connection is a NULL MODEM
cable, and can be obtained from EMERSON EMC. COM1 on the T-60 is
connected to the DX drive via a TIA cable also available from EMC.
Baud rates and setup
The build software should be able to communicate with the T-60 without
deviation from the default comm parameters. The DX drive serial parameters
must be set up as desired along with the axis id. These parameters will be
matched by the COM initialization pseudo-command provided by the builder
software.
Figure 14
Installation - T-60 W/More
Than One DX Drive
T-60 Operator's Manual
34