Filter
Top Products
-IDEC FA-1J\FA2-J Interface Option
Communications:
The -IDEC option uses the Idec protocol to communicate between the Series
T-60 unit and the PLC. The unit is configured by using the
-plcinit(x,y)
command.
Connections:
In order for the SeriesT-60 and the Idec unit to communicate, a specialized
cable is sent with the Eason unit. The pinout for this cable is shown in the
table below illustrating the view for both the T-60 and the T-61.
Parameter— Mode Baud Rate Data Bits Stop Bit(s) Parity
FA-1J— RS232 C9600 baud 8 1 None
FA-2J— RS232 C9600 baud 8 1 Even
Table 13
T60 Series / RS232
Communication Protocol
-IDEC FA-1J\FA2-J Interface
Option
Figure 28
T-60 Series to IDEC FA-1J and
FA-2J PLC Communication
Connections
PLC Interface Commands PLC Specific Information
89