Filter
Top Products
MRV Communications, Inc. – Installation Manual
63
In the 8” setup, the two devices are not centrally aligned; instead,
only one corner of each device faces the opposite device. This
allows for testing each transmitter separately. By rotating the devices
45 degrees, the next pair of transmitters is tested. Hence, testing all
6 transmitters in the link pair requires only 3 rotations. With opaque
masking tape, cover all transmitters that are not under test.
Table 1: Bench Test Information for TS Products
Product name
Opt. Power M. “Sub-Saturation”
value
Potential for
Interference
TSxxxx 1100 Low
TSxxx/ETH 1200 Med
TSxxx/E1 1200 High
TSxxxx/ST 1200 Med
TS2000/XXX 1100 High
TS4000/XXX 1200 High
TS5000/XXX 1000 High
Figure E.1: Bench Test setup for 4”/Light TS models.
Figure E.2a: Bench Test setup for 10” TS model; transmitter aligned opposite receiver
marked with arrows.