Filter
Top Products
Chapter 2 Measurement Studio Measurement Computing Edition .NET Class Libraries
© National Instruments Corporation 2-31 Measurement Studio for MCC User Manual
With the knob, gauge, and meter controls and the classes that interface with
the controls, you can perform the following operations:
• Specify the start and sweep angle of the arc programmatically or from
the Properties window.
• Use automatic division spacing, custom divisions, and invert the scale.
Use the Measurement Studio slide, tank, and thermometer controls, as
shown in Figure 2-16, to input and display numeric data on your interface.
Figure 2-16. Web Forms Slide, Tank, and Thermometer Controls
With the slide, tank, and thermometer controls and the classes that interface
with them, you can perform the following operations:
• Fill to the minimum or maximum value of the scale.
• Position the scale horizontally with left, right, or both and position the
scale vertically with top, bottom, or both.
Tip For more information about using the Web Forms knob, gauge, meter, slide, tank, or
thermometer controls, refer to the Knob, Gauge, Meter, Slide, Tank, or Thermometer Class
sections in the NI Measurement Studio Help.