Filter
Top Products
Index
NI 8352/8353 User Manual I-8 ni.com
RAID HDD, resetting, C-4
RAID volume, deleting, C-4
RAID0 volume, creating, C-1
RAID1 volume, creating, C-2
RAID10 volume, creating, C-2
RAID5 set, creating, C-3
RAM
DDR DIMMs from National Instruments
(note), 1-6
upgrading, 4-4
Realtime Sensor Data, 2-20
rear panel connectors, 3-1
related documentation, x
replacing hard disk drives, B-20
Reset Configuration Data, 2-10
Resume on Modem Ring, 2-8
Route Port 80h Cycles to, 2-12
S
safety and caution notices, 2-1
safety ground, connecting, 2-3
safety specifications, A-4
SATA AHCI, 2-5
SATA connector locations (figure), B-20
SATA connectors, SATA0 to SATA3, B-21
SATA Controller Mode, 2-4
SATA Port3, 2-5
SATA Port4, 2-5
SATA RAID utility, C-1
SATA0 and SATA3 connector (figure), B-21
Save Changes, 2-22
Security, 2-20
Serial ATA, 2-4
Serial ATA (SATA) RAID, 2-5
serial connector, 3-4
connector locations and pinout
(figure), 3-4
connector signals (table), 3-4
Serial Port A, 2-14
Serial Port B, 2-14
serial port header (COM2), B-12
pinout (figure), B-12
signals (table), B-12
serial ports, 3-1
See also COM1 and COM2 connectors
Set Supervisor Password, 2-20
Set User Password, 2-20
slide assemblies, installing into rack
(figure), 2-25
Slot1 PCI 32, 2-10
Slot6 PCI-Exp. x8, 2-10
Slot6 PCI-X 133 MHz, 2-10
SMBus to PCI/PCI-Express slots jumper
JI
2
C1/JI
2
C2) settings, B-4
software
See also drivers
LabVIEW, 1-7
LabWindows/CVI, 1-7
Measurement Studio, 1-7
National Instruments software, 1-7
NI resources, D-1
NI-DAQmx, 1-7
NI-VISA, 1-8
specifications
CE compliance, A-4
CPU, A-2
electrical, A-1
electromagnetic compatibility, A-4
environmental, A-3
environmental management, A-5
hard disk drive, A-3
mainboard, A-1
mechanical, A-3
memory, A-3
safety, A-4
Summary Screen, 2-8
Supervisor Password Is:, 2-20
support, technical, D-1
System Date, 2-4
System Event Log, 2-20
System Event Log (List Mode), 2-20