Filter
Top Products
Chapter 2 Installation and BIOS Setup
© National Instruments Corporation 2-15 NI 8352/8353 User Manual
Interrupt
Use this setting to select the interrupt request (IRQ) for serial port B. The
options are IRQ3 (default) and IRQ4.
Parallel Port
Use this setting to assign parallel port control. The options are Enabled
(user defined, default), Disabled, and Auto (BIOS or OS controlled).
Base I/O Address
Use this setting to select the parallel port base I/O address. The options are
378 (default), 278, and 3BC.
Interrupt
Use this setting to select the parallel port interrupt request (IRQ). The
options are IRQ5 and IRQ7 (default).
Mode
Use this setting to specify the parallel port mode. The options are Output
only, Bi-Directional, EPP, and ECP (default).
DMA Channel
Use this setting to specify the parallel port DMA channel. The options are
DMA1 and DMA3 (default).
Floppy Disk Controller
Use this setting to assign control of the floppy disk controller. The options
are Enabled (user defined, default), Disabled, and Auto (BIOS and
OS controlled).
Base I/O Address
Use this setting to select the floppy port base I/O address. The options are
Primary (default) and Secondary.
DMI Event Logging
Access this submenu to change the following settings.
Event Log Validity
This display informs you of the event log validity. It is not a setting.