Filter
Top Products
Chapter 2 Installation and BIOS Setup
© National Instruments Corporation 2-5 NI 8352/8353 User Manual
When the SATA Controller Mode is set to Enhanced, the following items
display.
Serial ATA (SATA) RAID
Select Enabled to enable Serial ATA RAID functions. (For Windows, use
the RAID driver if this feature is set to Enabled. When this item is set to
Enabled, the ICH RAID Code Base item is available for you to select
activation of either Intel or Adaptec Host RAID firmware. If this item is set
to Disabled, the SATA AHCI Enable item is available.) The options are
Enabled and Disabled (default).
SATA AHCI
Select Enabled to enable the Serial ATA Advanced Host Interface
function. (Be careful when using this function. This feature is for advanced
programmers only.) The options are Enabled and Disabled (default).
ICH RAID Code Base
Select Intel to enable the Intel SATA RAID firmware. Select Adaptec to
use Adaptec's HostRAID firmware. The options are Intel (default) and
Adaptec.
IDE Primary Master/Slave, IDE Secondary Master/Slave,
SATA Port3, and SATA Port4
Use these settings to set the parameters of IDE Primary Master/Slave,
IDE Secondary Master/Slave, and SATA Port3/SATA Port4 slots. Press
<Enter> to access the following submenu items. Set the correct
configurations accordingly.
Type
Use this option to select the IDE hard drive type. The Auto (default) option
allows the BIOS to automatically configure the parameters of the HDD
installed at the connection. Enter a number between 1 to 39 to select a
predetermined HDD type. Select User to enter the parameters of the HDD
installed. Select CDROM if a CDROM drive is installed. Select ATAPI if
a removable disk drive is installed.