Filter
Top Products
Chapter 2 Installation and BIOS Setup
© National Instruments Corporation 2-3 NI 8352/8353 User Manual
6. Connect the MXI-Express port on the rear of the NI 8352/8353 to the
PXI chassis and power on the chassis.
7. Power on the NI 8352/8353.
8. Verify that the NI 8352/8353 boots. If it does not boot, refer to the
What if the NI 8352/8353 does not boot? section of Chapter 5,
Troubleshooting.
Connecting Safety Ground
The NI 8352/8353 is designed with a three-position NEMA 5-15 style plug
for the U.S. that connects the ground line to the chassis ground. To
minimize shock hazard, make sure the electrical power outlet you use to
power the chassis has an appropriate earth safety ground.
Connecting to Power Source
Attach input power through the rear AC inlet using the appropriate
AC power cable supplied.
Caution To completely remove power, you must disconnect the AC power cable.
The power switch allows you to power on the chassis or place it in standby
mode. Push the power switch to the On position (if not already on). Observe
that all fans become operational and the power indicator is lit.
BIOS Setup
This section describes all main BIOS setup options.
Use the up/down arrow keys to move among the different settings in each
menu. Use the left/right arrow keys to change the options for each setting.
Press <Esc> to exit the CMOS setup menu. The next section describes in
detail how to navigate through the menus.
To access submenus, highlight a menu item and press <Enter>.