Filter
Top Products
Setting Up Your Server 3-23
4. Remove four screws C located at both side of the front face of the server to fix it.
1
2
5. Hold the handle to pull out the server from the rack slowly and carefully.
The server clicks to be latched.
6. Push the left and right release levers to release the latch and then pull out the server from
the rack slowly.
IMPORTANT:
Push each release lever using a driver or a similar tool. Pushing a
release lever with your fingers may cause the fingers to be caught
and thus injured.
Pull out the server slowly with the bottom supported by more than
one person.
Secure the power cord(s) and interface cables with a lock spring.
Form the power cord with a slight slack at the AC inlet of the server.
This is to prevent the power cord from coming off when the server
is pulled out from the rack.
Do not apply any pressure to the plug of the power cord.
See the "Installation procedure" when the mechanical components of the rack are removed also.
Unlock Lock
Release lever