Filter
Top Products
Setting Up Your Server 3-27
Connection between the RJ-45 Serial Port and a Modem
To connect a modem to the RJ-45 serial port, use the optional "serial port conversion cable" with the
"R" label attached. Be careful not to use the other one with the "F" label attached. Set the jumper
pin to "DCD+DSR" (factory-set).
IMPORTANT: Make sure of the icon of the server, and be sure to
connect the cable to serial port B. Be careful not to connect to a LAN
port by mistake.
To prevent wrong connection, write "LAN port" on a tag and put the tag
to the connector of the LAN cable that is to be connected to this server.
Wiring block diagram of the internal cables:
RJ-45 serial port Serial port conversion
cable (with the R label
attached)
DTE-DCE straight cable DCE