Filter
Top Products
CHAPTER 2 ND-46550 (E)
Page 6
Revision 2.0
4. REQUIRED EQUIPMENT
Table 2-2 shows the required equipment for establishing the Remote PIM System.
Table 2-2 Required Equipment
EQUIPMENT NAME DESCRIPTION
SN1308 PIM P-A (PIM Q-UA) Port Interface Module for Small Platform System/Remote PIM system
(remote site)
A PIM provides 13 card slot for common control, Line/Trunk cards. It
also houses a AC/DC power supply and optional batteries for protection
from short-term power interruption.
Three champ connectors for line/trunk (LTC0 to 2) and a connector for
Power (PWR) are located at the lower front side of the PIM.
SN1420 PIMAB-A Port Interface Module (PIM) for 1000 IVS/Remote PIM system (remote
site).
A PIM provides 10 card slots for common control, Line/Trunk, and
Application Processor (AP) cards. It is also houses a AC/DC Power Sup-
ply and batteries for protection from short-term power interruption.
Two champ connectors for line/trunk (LTC0 to 1) and a connector for
Power (PWR) are located at the lower front side of the PIM.
PN-DAIA (DAIA Card) Interface card for Remote PIM System at main site
This card provides 1.5 Mbps (24 channel) digital interface, firmware
processor, and BUS interface; 1 through 3 DAIA cards must be provided
at main site, which corresponds to the number of the remote site.
PN-DAIB (DAIB Card) Interface card for the Remote PIM System at remote site
This card provides 1.5 Mbps (24 channel) digital interface, firmware
processor; 1 card is required per Remote PIM at the remote site.
PIM N-UB Port Interface Module for 128/512 port systems/Remote PIM system.
This PIM can be a Remote PIM or main office PIM.
This PIM provides 19 slots for common control line and trunk cards. This
PIM houses an AC/DC power supply and optional batteries for short-term
power interruption.
Three champ connectors for line/trunk (LTC0 to 2) and a connector for
Power (PWR) are located at the lower front side of the PIM.