NetComm NCT480 Network Router User Manual


 
YML856 Rev3 NCT480 IP DSLAM User GuideNCT480 IP DSLAM User Guide
www.netcomm.com.au 43
Bridge Mode
The bridge configuration allows you to control the system bridging parameters.
Figure 2-5 Bridge Mode Dialog
Item Description
Aging Time
The timeout period, in seconds, for aging out dynamically learned forwarding
information from CPEs. The value 0 can be configured when aging is to be stopped.
Valid values: 10 ~ 1,000,000
Uplink Aging Time
The timeout period, in seconds, for aging out dynamically learned forwarding
information from uplink side port. This is used only for full bridge configuration. The
value 0 can be configured when aging is to be stopped. Default is set to 600 sec.
Valid values: 10 ~ 1,000,000
Dnlink (Slave) Aging Time
The timeout period, in seconds, for aging out dynamically learned forwarding
information learned from the downlink device. The value 0 can be configured when
aging is to be stopped. Default is set to 600 sec.
Valid values: 10 ~ 1,000,000
Flood Support
This is used to specify whether the unknown unicast packets are to be flooded or
not. The value for this is used along with per vlan configuration for flood support to
determine if flooding has to be done for unknown unicast packet.
Broadcast Support
This is used to specify whether the broadcasting is supported or not. The value for
this is used along with per vlan configuration broadcast support, to determine if
broadcasting has to be done for the broadcast packet.
Multicast Support
Used to specify whether the multicast is supported or not.
Multicast Drop
If multicast is not supported, this setting can specify whether the multicast packets are
to be dropped, or to be forwarded.