Filter
Top Products
Advanced Settings
108
D6200 WiFi DSL Modem Router
The D6200 WiFi DSL modem router is always in dual-band concurrent mode, unless you turn
off one radio. If you enable the wireless repeater in either radio band, the wireless base
station or wireless repeater cannot be enabled in the other radio band. However, if you
enable the wireless base station in either radio band and use the other radio band as a
wireless WiFi DSL modem router or wireless base station, dual-band concurrent mode is not
affected.
For you to set up a wireless network with WDS,
the following conditions have to be met for
both access points:
• Both access points have to use the same SSID, wireless channel, and encryption mode.
• Both access points have to be on the same LAN IP subnet.
That is, all the access point
LAN IP addresses are in the same network.
• All LAN devices (wired and wireless computers) have to be configured to operate in the
same LAN network address range as the access points.
Wireless Repeating Function
Use the Wireless Repeating Function screen to view or change the wireless repeater
settings.
To view or change the wireless repeater settings:
1. Select ADV
ANCED > Advanced Setup > Wireless Repeating Function.
2. Configure the following settings:
• Enable W
ireless Repeating Function. Select the check box for the 2.4 GHz or 5
GHz network to use the wireless repeating function.