Filter
Top Products
Switching Commands
187
ProSafe M4100 and M7100 Managed Switches
lldp med transmit-tlv all
Use this command to specify which optional Type Length Values (TLVs) in the LLDP MED
set will be transmitted in the Link Layer Discovery Protocol Data Units (LLDPDUs).
Default
Format lldp med transmit-tlv all [capabilities] [ex-pd] [ex-pse] [inventory]
[location] [network-policy]
Mode
capabilities
ex-pd
ex-pse
inventory
location
network-policy
no lldp med transmit-tlv
Use this command to remove a TLV.
Format no lldp med transmit-tlv all [capabilities] [network-policy] [ex-pse]
[ex-pd] [location] [inventory]
Mode
show lldp med
Use this command to display a summary of the current LLDP MED configuration.
Format show lldp med
Mode
By default, the capabilities and network policy TLVs are included.
Global Config
Term Definition
Transmit the LLDP capabilities TLV.
Transmit the LLDP extended PD TLV.
Transmit the LLDP extended PSE TLV.
Transmit the LLDP inventory TLV.
Transmit the LLDP location TLV.
Transmit the LLDP network policy TLV.
Global Config
Privileged Exec
Term Definition
Fast Start
Repeat Count
The number of LLDP PDUs that will be transmitted when the protocol is enabled.
Device Class
The local device’s MED Classification. There are four different kinds of devices, three of
them represent the actual end points (classified as Class I Generic[IP Communication
Controller etc.], Class II Media Conference Bridge etc.], Class III Communication [IP
Telephone etc.]. Class IV Network Connectivity Device, which is typically a LAN Switch,
Router, IEEE 802.11 Wireless Access Point, etc.