Filter
Top Products
Power over Ethernet (PoE) Commands
505
ProSafe M4100 and M7100 Managed Switches
Dynamic Power Management
Available power = 300 watts - 3 watts = 297 watts
no poe power management
Use this command to set the power management mode to the default.
poe priority
Use this command to configure the priority on a specific port. This is used for power
management purposes. The switch might not be able to supply power to all connected devices,
so the port priority is used to determine which ports will supply power if adequate power capacity
is not available for all enabled ports. For ports that have the same priority level, the lower
numbered port will have higher priority. There are three options:
• Crit—Critical priority
• High—High priority
• Low—Low priority
no poe priority
Use this command to set the priority to the default.
poe reset
Use this command to reset the PoE state of every port (in global mode) or a specific port (in
interface mode). When the PoE port status is shown to be in an error state, this command can be
used to reset the PoE port. The command can also reset the power-delivering ports. Note that
Format poe power management {<unit>|all} {dynamic | static}
Mode Global Config
Default dynamic
Format no poe power management {<unit>|all}
Mode Global Config
Format poe priority { Crit | High | Low }
Mode Global Config
Interface Config
Default low
Format no poe priority
Mode Global Config
Interface Config