Filter
Top Products
Management Commands
675
ProSafe M4100 and M7100 Managed Switches
no snmp-server enable traps multiusers
Use this command to disable Multiple User traps.
Format no snmp-server enable traps multiusers
Mode
snmp-server enable traps stpmode
Use this command to enable sending new root traps and topology change notification traps.
Default
Format snmp-server enable traps stpmode
Mode
no snmp-server enable traps stpmode
Use this command to disable sending new root traps and topology change notification traps.
Format no snmp-server enable traps stpmode
Mode
snmptrap
Use this command to add an SNMP trap receiver. The maximum length of <name> is 16
case-sensitive alphanumeric characters. The <snmpversion> is the version of SNMP. The
version parameter options are snmpv1 or snmpv2. The SNMP trap address can be set using
both an IPv4 address format as well as an IPv6 global address format.
The following shows an example of the CLI command.
(Netgear Switch)# snmptrap mytrap ip6addr 3099::2
Note: The <name> parameter does not need to be unique, however; the
<name> and <ipaddr | hostname> pair must be unique. Multiple
entries can exist with the same <name>, as long as they are
associated with a different <ipaddr | hostname>. The reverse
scenario is also acceptable. The <name> is the community name
used when sending the trap to the receiver, but the <name> is not
directly associated with the SNMP Community Table, See
“snmp-server community” on page39.”
Global Config
enabled
Global Config
Global Config