Filter
Top Products
Switching Commands
83
ProSafe M4100 and M7100 Managed Switches
no dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state
machine on this port to the default values. Depending on the token used, the corresponding
default values are set.
Format no dot1x timeout {guest-vlan-period | reauth-period | quiet-period |
tx-period | supp-timeout | server-timeout}
Mode
dot1x unauthenticated-vlan
Use this command to configure the unauthenticated VLAN associated with that port. The
unauthenticated VLAN ID can be a valid VLAN ID from 0-Maximum supported VLAN ID
(4093 for 7000 series). The unauthenticated VLAN must be statically configured in the VLAN
database to be operational. By default, the unauthenticated VLAN is 0, i.e. invalid and not
operational.
Default
Format dot1x unauthenticated-vlan <vlan id>
Mode
supp-timeout
The value, in seconds, of the timer used by the authenticator state machine on this port
to timeout the supplicant.
The supp-timeout must be a value in the range 1 - 65535.
server-timeout
Default
• guest-vlan-period: 90 seconds
• reauth-period: 3600 seconds
• quiet-period: 60 seconds
• tx-period: 30 seconds
• supp-timeout: 30 seconds
• server-timeout: 30 seconds
Format dot1x timeout {{guest-vlan-period <seconds>} |{reauth-period
<seconds>} | {quiet-period <seconds>} | {tx-period <seconds>} |
{supp-timeout <seconds>} | {server-timeout <seconds>}}
Mode
The value, in seconds, of the timer used by the authenticator state machine on this port
to timeout the authentication server
. The supp-timeout must be a value in the range 1 -
65535.
Interface Config
Interface Config
0
Interface Config
Tokens Definition