Filter
Top Products
Routing Commands
226
ProSafe M4100 and M7100 Managed Switches
show arp
This command displays the Address Resolution Protocol (ARP) cache. The displayed results
are not the total ARP entries. To view the total ARP entries, the operator should view the
show arp results with the show arp switch results.
Format show arp
Mode
Age Time
(seconds)
Response Time
(seconds)
Retries
Cache Size
Dynamic Renew
Mode
Total Entry Count
Current / Peak
Static Entry Count
Configured/Active
/ Max
The following are displayed for each ARP entry:
IP Address
MAC Address
Interface
Type
Age
show arp brief
This command displays the brief Address Resolution Protocol (ARP) table information.
Format show arp brief
Mode
Privileged EXEC
Term Definition
The time it takes for an ARP entry to age out. This is configurable. Age time is
measured in seconds.
The time it takes for an ARP request timeout. This value is configurable. Response
time is measured in seconds.
The maximum number of times an ARP request is retried. This value is configurable.
The maximum number of entries in the ARP table. This value is configurable.
Displays whether the ARP component automatically attempts to renew dynamic ARP
entries when they age out.
The total entries in the ARP table and the peak entry count in the ARP table.
The static entry count in the ARP table, the active entry count in the ARP table, the
active entry count in the ARP table, and maximum static entry count in the ARP table.
Term Definition
The IP address of a device on a subnet attached to an existing routing interface.
The hardware MAC address of that device.
The routing slot/port associated with the device ARP entry.
The type that is configurable. The possible values are Local, Gateway, Dynamic and
Static.
The current age of the ARP entry since last refresh (in hh:mm:ss format)
Privileged EXEC