Filter
Top Products
Interface
Type
• Mirror - this port is a monitoring port. For more information, see Port Mirroring on
page 121.
• PC Mbr- this port is a member of a port-channel (LAG).
• Probe - this port is a probe port.
Admin Mode
Physical Mode
Physical Status
Link Status
Link Trap
LACP Mode
Switching Commands
26
ProSafe M4100 and M7100 Managed Switches
show port protocol
This command displays the Protocol-Based VLAN information for either the entire system, or
for the indicated group.
Format show port protocol {<groupid> | all}
Mode
Term Definition
Valid slot and port number separated by forward slashes.
If not blank, this field indicates that this port is a special type of port. The possible
values are:
The Port control administration state. The port must be enabled in order for it to be
allowed into the network. - May be enabled or disabled.
The factory default is enabled.
The desired port speed and duplex mode. If autonegotiation support is selected, the
duplex mode and speed is set from the auto-negotiation process. Note that the
maximum capability of the port (full-duplex -100M) is advertised. Otherwise, this object
determines the port's duplex mode and transmission rate.
The factory default is Auto.
The port speed and duplex mode.
The Link is up or down.
This object determines whether to send a trap when link status changes. The factory
default is enabled.
LACP is enabled or disabled on this port.
Privileged EXEC
Term Definition
Group Name
The group name of an entry in the Protocol-based VLAN table.
Group ID
The group identifier of the protocol group.
Protocol(s)
The type of protocol(s) for this group.
VLAN
The VLAN associated with this Protocol Group.
Interface(s)
Lists the slot/port interface(s) that are associated with this Protocol Group.