Filter
Top Products
Hardware Setup
9
N600 Wireless Dual Band Gigabit Router WNDR3700v4
The following table describes the LEDs, icons, and buttons on the front panel from left to
right.
Icon Description
Power
• Solid amber. The unit is starting up after being powered on.
• Solid green. The
router is ready to use
• Off. Power is not supplied to the router.
• Blinking green. The
firmware is corrupted. Visit www.netgear.com/support.
• Blinking amber. The
firmware is upgrading, or the Restore Factory Settings button
was pressed.
Internet
• Solid green. An IP address has been received; the routerready to transmit data.
• Solid amber.
The Ethernet cable connection to the modem has been detected.
• Off. No Ethernet cable is connected to the modem.
2.4 GHz • Solid green.
The 2.4-GHz wireless radio is operating.
• Off.
The 2.4-GHz wireless radio is off.
5 GHz • Solid blue. The
5-GHz wireless radio is operating.
• Off. The
5-GHz wireless radio is off.
LAN
• Solid green. The LAN port has detected a 1 Gbps link with an attached device.
• Solid amber.
The LAN port has detected a 10/100 Mbps link with an attached
device.
• Off. No link is detected on this port.
USB
• Solid green. The router has accepted the USB device.
• Blinking green.
The USB device is in use.
• Off. No USB device is connected, or the Safely Remove USB Drive button has been
clicked and it is now safe to remove the attached USB device.
Wireless
button
• Pressing this button for over one second turns on and off the wireless radios.
• On.
The 2.4-GHz and 5-GHz wireless radios are on.
• Off.
The 2.4-GHz and 5-GHz wireless radios are off, and the 2.4 GHz and 5 GHz
LEDs are off.
WPS button Pressing this button allows you to use Wi-Fi Protected Setup (WPS) to add a wireless
device or computer to your network (see Wi-Fi Protected Setup (WPS) Method on
page 19. The WPS LED blinks for 2 minutes during this process.