Filter
Top Products
RangeMax Wireless Router WPN824v3 User Manual
Technical Specifications and Default Configuration Settings A-3
v1.0, January 2008
Restoring the Default Settings
You can restore the factory default configuration settings to reset the router’s user name to admin,
the password to password, and the IP address to 192.168.1.1. This procedure erases your current
configuration, including your wireless security settings, and restores the factory defaults. When
you log in after resetting, the Smart Wizard configuration assistant prompts you to configure these
settings.
To restore the factory default configuration settings:
1. Use a sharp object such as a pen or a paper clip to press and hold the restore factory settings
button, located on the rear panel of the router, for about 10 seconds.
2. Release the restore factory settings button, and wait for the router to reboot.
The factory default settings are restored so that you can access the router from your Web
browser using the factory defaults.
Transmission speed Auto
a
Authentication type Automatic
Country/Region United States in the U.S., otherwise varies by region
RF channel 06
Operating mode Auto 108 Mbps
Data rate Best
Output power Full
a. Maximum wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will
vary. Network conditions and environmental factors, including volume of network traffic, building
materials and construction, and network overhead, lower actual data throughput rate.
Table A-2. wireless router Default Configuration Settings (continued)
Feature Default Setting