Filter
Top Products
Security 14-17
Modifying filter sets
To modify a filter set, select Display/Change IP Filter Set in the IP Filter Sets screen to display a list of filter
sets.
Select a filter set from the list and press Return. The Change IP Filter Set screen appears. The items in this
screen are the same as the ones in the Add Filter screen (see “Adding filters to a filter set” on page 14-14).
Deleting a filter set
Note: If you delete a filter set, all of the filters it contains are deleted as well. To reuse any of these filters in
another set, before deleting the current filter set you’ll have to note their configuration and then recreate them.
To delete a filter set, select Delete IP Filter Set in the IP Filter Sets screen to display a list of filter sets.
Select a filter set from the list and press Return to delete it. Press Escape to exit the list without deleting the
filter set.
A sample IP filter set
This section contains the settings for a filter set called Basic Firewall, which is part of the Netopia R7200’s
factory configuration.
Basic Firewall blocks undesirable traffic originating from the WAN (in most cases, the Internet), but forwards all
traffic originating from the LAN. It follows the conservative “that which is not expressly permitted is prohibited”
approach: unless an incoming packet expressly matches one of the constituent input filters, it will not be
forwarded to the LAN.
Change IP Filter Set
Filter Set Name: Basic Firewall
Display/Change Input Filter...
Add Input Filter...
Delete Input Filter...
Display/Change Output Filter...
Add Output Filter...
Delete Output Filter...