Filter
Top Products
102 Chapter 2 CLI Command Summary
311645-A Rev 00
reload in
This command sets a timer that causes the switch to reboot after a certain time has
passed. Options can be specified to determine whether the switch turns off or
reboots, which configuration to use after a reboot, and other settings.
The user is prompted to confirm that they want to continue with the reload. If they
say yes and if the reload command is valid, the system reload will start at the
specified time.
Syntax
reload in [
hh
:]
mm
[power-off|restart
] [
boot-safe|boot-normal
]
[
boot-drive {ide0|ide1}
]
[
config-file
{
latest|factory|config-name
}] [
disable-logins
]
[
disable-after-restart
] [
text
]
Parameters
[
hh|
mm] The hours and minutes that must pass before the shutdown will
start. The allowed range is 00:01 to 24:00.
power-off If present, the switch will power down after it has completed
shutdown.
restart If present, the switch restarts after it has completed shutdown.
boot-safe If present, switch restarts in safe boot mode.
boot-normal If present, switch restarts in normal boot mode.
boot-drive Specify the drive from which the switch will reboot.
ide0|ide1 Disk drive from which that bootable image will be loaded.
config-file Specify which configuration should be used after a reboot.
latest The switch should be rebooted with the latest configuration file.