Filter
Top Products
106 Chapter 2 CLI Command Summary
311645-A Rev 00
reload no-sessions
This command causes the switch to reboot after there are no further logins. The
reboot will start after all tunnels into the box, and all management sessions
(Telnet, Web, etc.) have been closed. Options can be specified to determine
whether the switch turns off or reboots, which configuration to use after a reboot
and other settings.
The user is prompted to confirm that they want to continue with the reload. If they
say yes and if the reload command is valid, the system reload will start a short
time after all sessions (tunnels and administrative) have disconnected.
Syntax
reload no-sessions [power-off|restart] [boot-safe|boot-safe]
[boot-drive {ide0|ide1}]
[config-file {latest|factory|config-name}] [disable-logins]
[disable-after-restart] [text]
Parameters
no-sessions Indicates the reboot will start once there are no more
sessions connected to the switch.
power-off If present, the switch will power down after it has completed
shutdown.
restart If present, the switch restarts after it has completed shutdown.
boot-safe If present, switch restarts in safe boot mode.
boot-normal If present, switch restarts in normal boot mode.
boot-drive Specify the drive from which the switch will reboot.
ide0|ide1 Disk drive from which the bootable image will be loaded.
config-file Specify which configuration should be used after a reboot.
latest The switch should be rebooted with the latest configuration file.