Filter
Top Products
94 Chapter 2 CLI Command Summary
311645-A Rev 00
Example
CES#reload restart boot-drive ide0 config-file factory
disable-after-restart Upgrade software
Reload Scheduled Shutdown
Reload Explanation: Upgrade software
After Shutdown: Restart
Disable New Logins: No
Disable Logins after Restart: Yes
Boot Mode: Normal
Config File: Reset Config File
Boot Drive: /ide0/
Proceed with reload? [confirm]y
This reboots the switch from ide0, using the factory installed defaults and
disabling logins after the reboot to allow for system maintenance. Reason is to
"Upgrade software." The user must press [CR], or any subset of the string “yes”,
to confirm that they want the reload to proceed.
Comments
After a successful reload command, the switch will reboot in approximately 10
seconds. For most Telnet client software, the reboot will cause the Telnet client to
close the connection to the switch.
If there are any outstanding reboot commands, they will be canceled. There can
only be one reboot scheduled at any time.