Filter
Top Products
Chapter 2 CLI Command Summary 185
Reference for the Contivity VPN Switch Command Line Interface
trace
The trace command allows the administrator to determine the route that packets
use when traveling to their destination. It is commonly used as a diagnostic
command (traceroute on most systems).
The trace command does not recognize DNS names with hyphens.
Syntax
trace ip {host | address} [hops number] [wait timeout]
Parameters
host The trace packets to the system identified by this host name.
address The trace packets to the system identified by this dotted IP
address.
hops number Specify the maximum hops.
wait timeout Specify the wait timeout in seconds.
Default
The wait timeout defaults to 5 seconds.
The maximum hops defaults to 30.
Command mode
User Exec
Next command mode
User Exec