Filter
Top Products
Chapter 1 Introduction 35
Reference for the Contivity VPN Switch Command Line Interface
User Exec Mode
This is the initial command mode when the administrator first establishes a Telnet
connection to the switch. It is also called Exec mode.
This is a limited display mode. You cannot modify configuration parameters or
view the configuration file.
User Exec Mode prompt
CES>
User Exec Mode commands
The following table summarizes the User Exec Mode commands.
Table 1 CLI Modes, Prompts and Access
Mode Prompt Access
User Exec Mode CES> Login via
Telnet
with
administrator name
and
password
.
Privileged Exec Mode CES# Enter the command
enable
at the User Exec
Mode prompt.
Global Config Mode
CES(config)#
Enter the command
configure terminal
at
the Privileged Exec Mode prompt.
Table 2 User Exec Mode Commands
Command Description
clear ip route Remove a route from the route table
enable Enable privileged commands
exit Exit the Telnet session
help Display message about using help
ping Send ping message to a destination
show file systems List available file systems
show flash: contents Display flash settings