Filter
Top Products
DTI software implementation 251
LD 73 - Defining the grade of service timers for the DTI card
Prompt Response Description
CRC NC mt dt ct ot Cyclic redundancy check error counts.
NC = Error count values are in the range 1-255.
mt = Maintenance threshold time (MNT).
dt = No new data calls threshold time (NNDC).
ct = No new calls threshold time (NNC).
ot = Out of service threshold time (OOS).
Note: The following requirements must be met for input.
mt = Maintenance threshold is equal to or greater than dt.
dt = Data calls threshold is equal to or greater than ct.
ct = Calls threshold is equal to or greater than ot.
BPV NB mt dt ct ot Bipolar violation error counts.
NB = Error count values are in the range 1-255.
mt = Maintenance threshold time (MNT).
dt = No new data calls threshold time (NNDC).
ct = No new calls threshold time (NNC).
ot = Out of service threshold time (OOS).
Note: The following requirements must be met for this input: mt
= >dt = >ct = >ot.
FAP NF mt dt ct ot Frame alignment problem thresholds.
NF = Error count values are in the range 1-255.
mt = Maintenance threshold time (MNT).
dt = No new data calls threshold time (NNDC).
ct = No new calls threshold time (NNC).
ot = Out of service threshold time
Note: The following requirements must be met for this input: mt
= >dt = >ct = >ot.
SLP NS mt dt ct ot Maintenance threshold slip count.
NS = Error count values are in the range 1-255.
mt = Maintenance threshold time (MNT).
dt = No new data calls threshold time (NNDC).
ct = No new calls threshold time (NNC).
ot = Out of service threshold time (OOS).
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.