Filter
Top Products
PRI software implementation 277
Prompt Response Description
On an existing ESN network, setting this prompt to "YES"
may also require modifying the Digit Manipulation Index (DMI)
associated with this route at the far-end (so the Access Code is
not reinserted twice). The INSERT prompt (INST) is bypassed if
INAC = YES.
LD 14 - Defining service channels and PRI trunks
Prompt Response Description
REQ NEW
CHG
Add new data.
Change existing data.
Note: When assigning several members at once use the multiple
create command NEW XX.
TYPE TIE TIE trunk only, allowed between MSL-1.
TN l ch Loop and channel for digital trunks
RTMB
0-511 1-4000
Route number and Member number
Range for Large System and CS 1000E system.
0-127 1-4000
Range for Meridian 1 Small System, Media Gateway 1000B,
...
LD 73 - Defining system timers and clock controller parameters
Prompt Response Description
REQ CHG Change data.
TYPE PRI2 2.0 Mb PRI.
FEAT SYTI System timers.
CCO
xx
Card slot number for Clock Controller 0.
PREF CCO
xx
Card number of PRI/DTI/SILC containing the primary clock
reference for the main cabinet
SREF CCO
xx
Card number of PRI/DTI/SILC containing the primary clock
reference for the main cabinet
CC1
xx
Card number for Clock Controller 1.
PREF CC1
xx
Primary Reference DTI/PRI loop for Clock controller one.
SREF CC1
xx
Primary Reference DTI/PRI loop for Clock controller one.
CC2
xx
Card number for Clock Controller 2.
PREF CC2
xx
Card number of PRI/DTI/SILC or DTI2/PRI2/SILC containing the
primary clock reference.
SREF CC2
xx
Card number of PRI/DTI/SILC or DTI2/PRI2/SILC containing the
primary clock reference.
CC3
xx
Card number for Clock Controller 3.
Nortel Communication Server 1000
ISDN Primary Rate Interface Installation and Commissioning
NN43001-301 02.03 Standard
Release 5.5 7 December 2007
Copyright © 2003-2007, Nortel Networks
.