Configuring RF load balancing for APs 251
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Disabling or re-enabling RF load balancing
RF load balancing is enabled by default globally on the WSS switch and for individual radios. To disable or re-enable
RF load balancing globally, use the following command:
set load-balancing mode {enable | disable}
To disable or re-enable RF load balancing for an individual radio, use the following command:
set ap ap-num radio radio-num load-balancing {enable | disable}
If RF load balancing has been enabled or disabled for a specific AP radio, then the setting for the individual radio takes
precedence over the global setting.