Filter
Top Products
438 Configuring quality of service
NN47250-500 (Version 03.01)
11a mandatory rate: 6.0,12.0,24.0 standard rates: 9.0,18.0,36.0,48.0,54.0
11b beacon rate: 2.0 multicast rate: AUTO
11b mandatory rate: 1.0,2.0 standard rates: 5.5,11.0
11g beacon rate: 2.0 multicast rate: AUTO
11g mandatory rate: 1.0,2.0,5.5,11.0 standard rates: 6.0,9.0,12.0,18.0,24.0, 36.0,48.0,54.0
(For more information about this command’s output, see the “AP Commands” chapter in the Nortel WLAN Security
Switch 2300 Series Command Line Reference.)
Displaying CoS mappings
WSS Software provides commands for displaying the default CoS mappings and configured mappings.
Displaying the default CoS mappings
To display the default CoS mappings, use the following command:
WSS# show qos default
Ingress QoS Classification Map (dscp-to-cos)
Ingress DSCP CoS Level
===============================================================================
00-09 0 0 0 0 0 0 0 0 1 1
10-19 1 1 1 1 1 1 2 2 2 2
20-29 2 2 2 2 3 3 3 3 3 3
30-39 3 3 4 4 4 4 4 4 4 4
40-49 5 5 5 5 5 5 5 5 6 6
50-59 6 6 6 6 6 6 7 7 7 7
60-63 7 7 7 7
Egress QoS Marking Map (cos-to-dscp)
CoS Level 0 1 2 3 4 5 6 7
===============================================================================
Egress DSCP 0 8 16 24 32 40 48 56
Egress ToS byte 0x00 0x20 0x40 0x60 0x80 0xA0 0xC0 0xE0
Displaying a DSCP-to-CoS mapping
To display the CoS value to which a specific DSCP value is mapped during classification, use the following command:
show qos dscp-to-cos-map dscp-value
Note. Configuration information for some settings appears in other chapters. To
configure transmit rates, or the long or short retry, see “For more information about MP-432
and 802.11n, see Nortel WLAN - Management Software Reference Guide.” on page 305.
To configure the user-idle timeout and idle-client probing, see “Displaying and changing
network session timers” on page 696.