Configuring APs 341
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Restarting an AP
To restart an AP, use the following command:
reset {ap port-list | ap ap-num}
Use the reset ap command to reset an AP configured on an AP access port. Use the reset ap command to reset a AP.
When you enter one of these commands, the AP drops all sessions and reboots.
Displaying AP information
You can display the following AP information:
• AP and radio-specific configuration settings
• Connection information for Distributed APs configured on a WSS
• List of Distributed APs that are not configured on a WSS
• Connection information for Distributed APs
• Service profile information
• Radio profile information
• Status information
• Information about static IP addresses on Distributed APs
• Statistics counters
Caution! Restarting an AP can cause data loss for users who are currently associated
with the AP.