Configuring APs 339
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Disabling or reenabling all radios using a profile
To disable or reenable all radios that are using a radio profile, use the following command:
set radio-profile name [mode {enable | disable}]
The following command enables all radios that use radio profile rp1:
WSS# set radio-profile rp1 mode enable
success: change accepted.
The following commands disable all radios that use radio profile rp1, change the beacon interval, then reenable the
radios:
WSS# set radio-profile rp1 mode disable
success: change accepted.
WSS# set radio-profile rp1 beacon-interval 200
success: change accepted.
WSS# set radio-profile rp1 mode enable
success: change accepted.