Filter
Top Products
Configuring APs 281
Nortel WLAN—Security Switch 2300 Series Configuration Guide
cos 0 If static CoS is enabled (static-cos is set to
enable), assigns CoS 0 to all data traffic to
or from clients.
dhcp-restrict disable Does not restrict a client’s traffic to only
DHCP traffic while the client is being
authenticated and authorized.
idle-client-probing enable Sends a keepalive packet (a null-data
frame) to each client every 10 seconds.
keep-initial-vlan disable Reassigns the user to a VLAN after
roaming, instead of leaving the roamed
user on the VLAN assigned by the switch
where the user logged on.
Note: Enabling this option does
not retain the user’s initial VLAN
assignment in all cases.
long-retry-count 5 Sends a long unicast frame up to five times
without acknowledgment.
no-broadcast disable Does not reduce wireless broadcast traffic
by sending unicasts to clients for ARP
requests and DHCP Offers and Acks
instead of forwarding them as multicasts.
proxy-arp disable Does not reply on behalf of wireless clients
to ARP requests for client IP addresses.
Instead, the radio forwards the ARP
Requests as wireless broadcasts.
psk-phrase No passphrase
defined
Uses dynamically generated keys rather
than statically configured keys to
authenticate WPA clients.
psk-raw No preshared key
defined
Uses dynamically generated keys rather
than statically configured keys to
authenticate WPA clients.
rsn-ie disable Does not use the RSN IE in transmitted
frames.
shared-key-auth disable Does not use shared-key authentication.
This parameter does not enable PSK
authentication for WPA. To enable PSK
encryption for WPA, use the
set radio-profile auth-psk command.
short-retry-count 5 Sends a short unicast frame up to five
times without acknowledgment.
soda disable Sygate On Demand Agent (SODA) files
are not downloaded to connecting clients.
Table 6: Defaults for service profile parameters (continued)
Parameter Default Value
Radio Behavior When Parameter Set
To Default Value