Filter
Top Products
24 Chapter 1 Contivity 4600 Option Installation
302283-E Rev 00
7
Plug in both power cords to the power source and turn on the switch.
Installing Contivity 4600 DIMMs
Figure 6
shows you how to unlock a DIMM in the Contivity 4600, and remove or
install a DIMM. Install a DIMM in the next available slot (for example, if the
DIMM #1 slot is populated, then add the next DIMM to the DIMM #2 slot).
To install a DIMM in the Contivity 4600, follow these steps:
1
Turn off the switch and unplug both power cords from the power source.
2
Unscrew the four slotted thumb-screws securing the slide-out tray. Pull out
the tray by gripping it with the screws. It will only pull out halfway.
3
Unscrew the slide-out tray at the back of the unit and pull it out using the
thumb screws.
4
Remove the support bracket by loosening the two secured captive screws and
the rear Phillips screw.
5
Press down the locking levers on both sides of the next available DIMM slot.
6
Place a new DIMM in the slot, making sure to properly position the DIMM's
alignment keys, as shown in Figure 5.
Caution:
Be careful when inserting option cards into the Contivity
4600, because the slide-out tray is not fully supported once pulled out.
You should support the back of the tray with your hand while inserting
an option card.