Filter
Top Products
Chapter 4 Contivity 2600 Option Installation 63
Installing Hardware Options for the Contivity VPN Switch
3
Remove the front bezel as shown in Figure 24.
4
Remove the top cover as shown in Figure 25.
5
Remove the filler panel screw and pull out the filler panel as shown in
Figure 27.
6
Slide the option card into the intended slot. Make sure the card seats firmly
and evenly into the card slot. If the card is not seated properly, it will not
work.
7
Replace the card and screw.
8
Replace the top cover.
9
Replace the front bezel.
Caution:
Be careful when inserting option cards into the Contivity
2600, as the slide-out tray is not fully supported once pulled out. You
should support the back of the tray with your hand while inserting an
option card.
Caution:
Be careful when inserting option cards into the Contivity
2600, as the slide-out tray is not fully supported once pulled out. You
should support the back of the tray with your hand while inserting an
option card.